Aircraft targets as seen by the CSU-CHILL radar: 16 March 2011

From CSU-CHILL

Revision as of 14:38, 18 March 2011 by Pat kennedy (talk | contribs)

Overview

Low elevation angle PPI scans detected many aircraft targets in the vicinity of Denver International Airport on 16 March 2011. The echoes received from aircraft are generally considered to be a corrupting factor in meteorological analyses of radar data.

Introduction

To make high-resolution observations of precipitation systems, weather radars typically use antennas that generate narrow (~ 1 to 3 degree wide) main beam patterns. Despite the use of these narrow "pencil" beams, weather radars still occasionally illuminate flying aircraft. During the afternoon of 16 March 2011, the CSU-CHILL radar conducted a continuous series of narrow PPI sector scans at an elevation angle of ~0.95 degrees centered over Denver International Airport. This scanning regime provided numerous examples of aircraft targets.

Reflectivity

The following loop contains ~22 minutes of data. The aircraft typically appear as single-gate targets. Due to the physical expansion of the radar pulse volume with range, the aircraft echoes are elongated in the cross-beam direction. The reflectivities vary as the aircraft climb and descend through PPI scan plane:


Click play to begin animation

Delay: ms

Linear
Rock

Differential Reflectivity

Aircraft present unpredictable polarimetric characteristics due to their large, complicated shapes (in comparison to raindrops); they can also maneuver into varying orientations, change landing gear positions, etc. The H and V signal returns from aircraft are also affected by the target's position within the antenna beam pattern. In the following loop, letters mark the successive positions of two example aircraft. Their Zdr values go through significant fluctuations. Users of weather radar data should be aware that aircraft echoes may be present within their data sets.


Click play to begin animation

Delay: ms

Linear
Rock